1, remove the number plates

2, remove the tail of the box

3, open the cover plate lights

4, the camera will be the power cord from the car license plate lights hole penetration and fixed-line

5, the camera will be fixed in the license plate shelves

6, the camera will be on the power cord from being negative relationship between inverted lights on the power

7, reducing the rear part by the demolition

8, insert Cigarette Lighter display power, placed a good display

8, start car, reversing put up stalls to display images of reversing

Attention to issues and difficult problems

        1, the camera will be the end of the power cable through the building, with a small wire-kan will be more smooth some traction.

        2, please note that inspections in reversing the luminous light camera is open, if not to open that power is not connected.

        3, should be fired to the plate on the car to the front of the place. Can not be placed on the back of the car steel plate sandwich, such as steel barrier may be, will affect the     camera and screen installed after no signal or poor image.