OLLO,HID,LED,DRL

Products list

Products search

Messages >>more

Contact Us

MSN:ollohid@ollohid.com
Email:ollohid@ollohid.com

phone:
0086-20-84268100
fax:
0086-20-84268100

News

Xenon headlights use shall comply with Attentions

Self-installation of HID xenon lamp removal may result in dangerous accidents.

  * Switch lamp power supply, please do not touch the bulb to avoid being a significant release of heat burns.
 * Car accidents and crash into the xenon headlights system, immediately turn off lights power, because of the damaged high-voltage ignition coil wire Unit will leak would be dangerous.

* Must be followed to start the car, and then open the auto xenon headlamps.

* Car engine must be shut down prior to HID Xenon lights off.

  * A few seconds, such as rapid light / off auto xenon lights, light bulbs can cause damage or shortened life expectancy.

  * Summer, night time mountain and highway driving, the engine compartment easy to overheat, if it headlights suddenly go out, do not panic, this phenomenon indicated that xenon headlights regulator installation location inappropriate. Caused by overheating, please drive the car to the curb immediately turn off the lights and power, the engine room to be cool, you can automatically return to normal, and go to car repair workshop to adjust the installation location.

  * Auto headlight assembly rupture or leakage of the phenomenon, rainy days, the absolute prohibition of turn on the lights to avoid danger.

  * Auto headlights turned on, xenon headlights light up, if not immediately, do not frequent lighting / lights-out, patiently wait for the regulator (central processing unit CPU) system will automatically do anything, continued to light up . If there is no light within a few minutes, please check the maintenance of plant, or burning caused by regulators.

  * Auto headlights switched on during or just after lights out, do not touch the hands or skin because of light bulb is very hot and may cause burns, car washing, or touch * Near the site of car headlights, first before the full cooling operation.
 

* Do not look directly at lights switched on due to cause eye pain or visual impairment, lighting * Do not look directly at the past.
 

* Distance light switch must be 2 ~ 3 seconds to do a switch, or likely to cause damage.

* Do not start the engine when the lighting in order to protect and extend the life of xenon headlights.

 In xenon headlights not turned on, do not use the switch to do to overtake overtaking moves, otherwise it might result in damage to xenon headlights

* When using the distance light, ultra-lights to do when you can not move or switch to a total of more than 10 times per minute switch, otherwise it will create flexible converter solenoid valve can not switch caused by burning high and low lights.DateTime:2010-01-28 01:30:15